OMNi INTEGRATED COMBO

SNORKEL TUBE INSTALLATION

1. To begin, slip the snorkel tube over the mount on top of the mask. The plastic tab on the snorkel tube should be facing behind the mask.  
2. Once the tube hits the colored O-ring seal, gently push it forward while moving the tube side-to-side and pushing down firmly. Angling the tube is important so that it can work itself over the O-ring  
3. Push firmly until the tube is flush with the mount on the mask. Do not use excessive force to install the tube. This tight fit helps prevent leaking while the mask is in use.  

PREPARATION 

When at the snorkel location, make sure there is no sand on the mask or tube. Sand can scratch the mask and impair breathing. If there is sand, rinse using water to clear sand from the breathing tube. 

Once the mask is clean and ready for use, attach the breathing tube. Make sure the breathing tube is clear of debris.  

CHECKING THE SEAL 

Pull the straps of the mask over your head and check the fit of the mask on your face. It should create a full seal around your face. Breathe normally to check for any leaks. If you feel a slight pressure change when you breathe then you have a good seal. 

If the mask is too loose or too tight take the mask off of your face and adjust the straps accordingly.  Please note that facial hair could prevent a proper seal and may cause leaking in the mask. For an optimal experience, shave any facial hair you may have.

USE 

Once in the water, breathe calmly through either your mouth and or nose. Calm breathing helps prevent fogging. Keeping your chin slightly up will create the best breathing experience. If you feel any obstruction to your breathing, it may be due to the snorkel being covered in water temporarily. The dry snorkel design will prevent water from entering through the top of the snorkel. If water leaks into your mask, simply lift your head out of the water and it will drain out of the chin valve. No need to remove your mask to clear it of water. To descend safely, simply pinch the nose pocket and gently blow to equalize as you slowly descend. 

PLEASE NOTE: if you feel any discomfort while equalizing stop use of this product immediately! 

CARE 

To maximize the life of your OMNi, rinse and soak with tap water using a small amount of detergent to help with cleaning. Wipe the mask down with a microfiber or non abrasive towel to prevent water spots and then allow the mask to air dry. Store the mask in a cool dry place and avoid exposure to direct sunlight and black rubber material as it could stain the silicone insert. Avoid leaving the mask in sandy areas when not in use.